Jtag Tutorial 3 | Soldering the wires and Making LTP conector

Jtag Tutorial 2 | Soldering the wires and Making LTP conector ►►►Read First◄◄◄ Please support all the hard work by subscribing to my videos, I appreciate it. ●▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬● what you need * xenon xbox360 * 5x 100ohm resistors * 3x 330ohm resistors * 1mtr kynar wire or cut up cat5 * 1x mal lpt connector (the type that you can unclick the plastic end bits to change pin config of the wires) * a pc with a printer port that operates in spp mode (standard parallel port) most old pc’s but some new pc’s have it * Coolshrimps freeboot installer what you need to do 1. solder in the lpt/jtag wires (as in the picture attached to this tutorial) 2. boot your pc to the bios settings ans set the lpt to spp mode 3. boot to windows xp (vista is incompatible) install dlportio driver and reboot pc 4. Open Freeboot installer and fallow the tutorial 🙂 ●▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬● Hope that you find this tutorial helpful and if you did remember to subscribe 🙂 ●▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬● Refer to this photo for the solder points 😉 lnk.co
Video Rating: 2 / 5

thai audio.Thai dub. In Mount Holliston, snowboarders Dan Walker, his girlfriend Parker O’Neil and his best friend Joe Lynch don’t have enough money to buy cable car tickets. Parker bribes Jason, an employee of the skiing station, with one hundred dollars. When the system is nearing closure, they force Jason to let them have the last pass. However, Jason needs to resolve a problem and his colleague misunderstands his instructions and stops the cable car, and the trio of snowboarders gets stranded on the chairlift on the top of the mountain. When they see that the lights of the ski resort had been turned off, they need to make a choice: leave the chairlift or freeze to death.
Video Rating: 4 / 5